Article Sidebar
Published:
Feb 14, 2024DOI:
10.4314/njt.v42i4.6Keywords:
Article Details
Copyright belongs to the Faculty of Engineering, University of Nigeria, Nsukka, Nigeria
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from https://www.nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in Statement of Originality.pdf (nijotech.com)
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.
Main Article Content
Box-Behnken optimization of pin-on-disc wear test process parameters
Abstract
The Full factorial and Box-Behnken Designs for determination of optimal values of wear rate using pin –on-disc wear test parameters have been successfully carried out. The parameters used are track diameter of the disc, mass difference of specimen before and after the test and speed of the disc. The mathematical model developed for the “smaller-the-better” wear rate response by the Full factorial and Box-Behnken Design methods were adjudged adequate with a pvalue of 0.025 and 0.046 respectively. Also, the adjusted R2 values of the Factorial and Box-Behnken Designs were determined to be 0.89 and 0.69 respectively. The statistical ANOVA analysis carried out on the Box-Behnken Design showed that the track diameter and the mass difference were significant with a p-value of 0.041 and 0.007 respectively. Contour plots and response surface plot developed for the factorial method and the Box-Behnken Design displayed appreciable level of similarity. It was noticed that a reduction of wear was occasioned by an increase in track diameter and speed of the disc.
