Article Sidebar
Published:
Nov 2, 2022DOI:
10.4314/njt.v41i3.6Keywords:
Article Details
Copyright belongs to the Faculty of Engineering, University of Nigeria, Nsukka, Nigeria
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from https://www.nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in Statement of Originality.pdf (nijotech.com)
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.
Main Article Content
Modelling the effect of lateral inertia on the dynamic response of aluminium square tube extrusions
Abstract
Crashworthiness of automotives require the design of crush tubes installed as a frontal structure to absorb energy by deforming plastically during collision. The crushing behaviour of aluminium extrusions modelled as square tubes is investigated under quasi-static and dynamic loading conditions using the non-linear explicit finite element code LS DYNA. Previous works have attributed the dynamic increase of the peak and mean crushing load of aluminium thin-walled structures under axial compression, to inertia effects. Results of our investigation revealed that there is a considerable thickening of the shell side walls before and during progressive folding. This shell thickening is established as the cause of lateral inertia which consequently results in increased crush strength. In addition, a positive correlation was established between the shell thickening and crushing speeds.
