Article Sidebar
Published:
Mar 24, 2021DOI:
10.4314/njt.v39i4.19Keywords:
Article Details
Copyright belongs to the Faculty of Engineering, University of Nigeria, Nsukka, Nigeria
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from https://www.nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in Statement of Originality.pdf (nijotech.com)
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.
Main Article Content
Investigating the effect of vibration on the stability of the three-wheeled scooter taxi
Abstract
The present three wheeled scooter taxi (TWST) that are widespread in Africa and Asian Countries are fuel economical and inexpensive. However, they are unstable due to their schematic layout. This instability places limitation on the usage of the vehicle. Researchers have investigated the rollover and lateral stabilities of this vehicle, including the effect of vibration on the comfort of the riders. However, not much work has been done on the impact of vibration on the stability of the vehicle. These instabilities could be induced by trenches, potholes, uneven and ungraded roads that are prevalent in developing countries. Therefore, this work modelled and analysed the effect of vibration on a TWST using a standard road bump as reference point. The results proved the vehicle to be unstable in the vicinity of excitation frequency of 15.95rad/sec and spring constant of 68,600N/m due to resonance. This would affect safety of life and property. Therefore, it would be appropriate for some of the manufacturers of these vehicles to provide for enough safety margins in the design and selection of springs where the vehicles are rollover and laterally unstable. This will enhance the vehicle safety and receptivity.
Keywords: Three wheeled Vehicle, Vibration Modelling and Analysis, Design, Safety of Life and Property
