Article Sidebar
Published:
Sep 16, 2020DOI:
10.4314/njt.v39i3.26Keywords:
Article Details
Copyright belongs to the Faculty of Engineering, University of Nigeria, Nsukka, Nigeria
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from https://www.nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in Statement of Originality.pdf (nijotech.com)
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.
Main Article Content
Comparative analysis of waste reduction methods for sustainable manufacturing systems using concurrent triangulation model
Abstract
The aim of this study is to carry out a comparative analysis of waste reduction methods for sustainable manufacturing systems using Cronbach alpha and concurrent triangulation model. The objective of this research is to establish an ideal sustainable manufacturing waste disposal method. Reliability test results showed that the Cronbach alpha values used to measure the internal consistency of responses recorded for recycling, reuse, reduce, remanufacture and landfilling were 0.8160 , 0.8100 , 0.7760 , 0.7550 and 0.7340 respectively with recycling recording the highest internal consistency. The concurrent triangulation model recorded results showed that recycling recorded a total of 184 respondents at the highest percentage of 51.11 %, reuse recorded a total of 58 respondents with 16.13 %, remanufacture recorded 43 respondents at 11.94%, reduce recorded a total of 38 respondents at 10.55 %, and Landfilling had 37 respondents with 10.27 %. Hence Recycling was selected as the most appropriate method.
Keywords: Concurrent Triangulation model, cronbach alpha, Recycling, Reuse, Remanufacturing, Sustainable manufacturing system.
