Article Sidebar
Published:
Jan 16, 2019DOI:
10.4314/njt.v38i1.23Keywords:
Article Details
Copyright belongs to the Faculty of Engineering, University of Nigeria, Nsukka, Nigeria
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from https://www.nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in Statement of Originality.pdf (nijotech.com)
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.
Main Article Content
Investigation of the transient and steady state operations of two Line Start Permanent Magnet Motors (LSPMMS) with different rotor configurations
Abstract
This paper investigates the transient and steady state operations of two Line Start Permanent Magnet Motors (LSPMMs) with different rotor types. The calculations showed that both designs can reach a higher efficiency than comparable induction motorsof the same size. The loading capability of the Surface Permanent Magnet (SPM) rotor is better than the Interior Permanent Magnet (IPM) rotor on asynchronous rotation as it has lesser torque ripples. However, IPM rotor had less flux leakage and copper losses at the synchronous operation under the same loading conditions.The results of the investigation also show that IPM motor attains a higher speed responses than SPM motor but SPM motor synchronizes faster than the IPM motor under the same loading conditions. During the asynchronous period, the chracteristics of both machines display similar features at a lower load torque less than 50N-m. The ripple contents of IPM is greater than that of SPM as can be observed in the run-up speed characteristics where IPM shows spontaneous overshoot. The pull out torque for SPM and IPM occurred at the time of 6 and 10 second respectively with same load increments.
Keywords: synchronous, asynchronous, motor, permanent magnet, torque
