Article Sidebar
Published:
Jul 23, 2018DOI:
10.4314/njt.v37i2.35Keywords:
Article Details
Copyright belongs to the Faculty of Engineering, University of Nigeria, Nsukka, Nigeria
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from https://www.nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in Statement of Originality.pdf (nijotech.com)
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.
Main Article Content
Use of the concept of Ive’s Filterability Number (F) to determine the effects of vacuum sludge filtration process
Abstract
The study highlights the laboratory use of the concept of Ive’s filterability number, ‘F’, recently formulated for sand filtration of wastewater. Ive,s Filterability Index Equation was modified and used to investigate the performance of sewage sludge undergoing vacuum filtration process. A simple modified form of Coacklely’s laboratory apparatus has been described for the evaluation of ‘F’. A sludge filtration experiment according to standard procedure suggested by Coackley was mounted. In calculating sludge filterability number and other parameters of the Ive,s equation, vacuum pressures of 20, 16, 12 and 8cmHg were used with the filter medium area of 23.6cm2. Four (4) sludge samples of different concentrations obtained from the University of Nigeria, Nsukka treatment plant were prepared. The data generated were used to calculate filterability number F, filtrate volume, Vo and instantaneous velocity ‘Vi’, for each filtration cycle. The values of ‘F’ for conditioned sludges were also evaluated from the data using regression analysis. On verification using the experimental data, the theorectical prediction of the modified equation was found to be in consonance with previous findings of other researchers. The filterability index from the generatd data was found to increase numerically with the applied vacuum pressures. Moreover, on verification with Alluminium Sulpahate (Al3SO4) on the effects of chemical conditioner on sludge filterability, it was observed that Filterability Index ‘F decreased with increased chemical dosages with the following results: 0.025g/ml, 0.0188g/ml, 0.0130g/ml of Al3SO4 gave corresponding decrease in values of filterability ‘F as 5.764, 5.970 and 6.134 for 0.00259g/Cm3 sludge sample. Similarly, sludge filterarbility showed an earlier increase with sludge initial solids content and reduced after the solids content was further increased with time, t. Such factors as pressure, initial solid content of sludge and chemical conditioning known to have effects on specific resistance and Sludge Dewaterability Number (SDN) have been found to have corresponding effects on sludge filterability index. These results further enhance the suitability of Ives filterability number concept as a measure of sludge filterability.
Keywords: Sludge, filterability Number, Vacuum, Specific Resistance
