Article Sidebar
Published:
Jul 23, 2018DOI:
10.4314/njt.v37i2.12Keywords:
Article Details
Copyright belongs to the Faculty of Engineering, University of Nigeria, Nsukka, Nigeria
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from https://www.nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in Statement of Originality.pdf (nijotech.com)
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.
Main Article Content
Characterization of Baruten Local Government Area of Kwara State (Nigeria) fireclays as suitable refractory materials
Abstract
Studies have shown that adequate attention needs to be paid on processing of solid minerals that are potentially available in Nigeria to address its economic problem. Clays from five major towns in Baruten Local Government Area, Kwara State, Nigeria were examined using ASTM guidelines to determine their suitability for refractory applications. The clay samples were classified as Alumino-Silicate refractories due to high values of Al2O3 and SiO2. The results showed apparent porosity (19.4-25.6%), bulk density (1.83-1.90 g/cm3), cold crushing strength (38.7-56.1 N/mm2), linear shrinkage (4.4 – 9.3%), clay contents (52.71-67.83%), moisture content (17.0-23.6%), permeability (68-82 cmsec-1), plasticity (16.7-30.4%), refractoriness (>1300oC) and Thermal Shock Resistance (23-25 cycles) for the clay samples, which were measurable with the established standards for fireclays, refractory clays/brick lining or alumina-silicates and kaolin. Hence, the natural clays could suitably replace imported clays in some refractory applications. Appropriate use of information from this study would improve Nigeria’s industrialization and economic diversification.
Keywords: Apparent Porosity, Bulk Density, Clay, Shrinkage and Refractory
