Article Sidebar
Published:
Jun 30, 2017DOI:
10.4314/njt.v36i3.19Keywords:
Article Details
Copyright belongs to the Faculty of Engineering, University of Nigeria, Nsukka, Nigeria
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from https://www.nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in Statement of Originality.pdf (nijotech.com)
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.
Main Article Content
EFFECT OF ALUMINUM DROSS AND RICE HUSK ASH ON THERMAL AND MOULDING PROPERTIES OF SILICA SAND
Abstract
Moulding properties of foundry sand should be controlled so as to minimize casting defects. Its thermal characteristics are vital in defining the solidification kinetics of a cast part, evolving microstructure and mechanical properties. Modification of the thermal properties of the moulding sand mix is important in achieving desired structure and mechanical properties in the cast component. This study investigates the incorporation of 2-12 wt. % aluminium dross (AlDr) and 1-6 wt. % rice husk ash (RHA) in silica sand on moulding and thermal properties of the resulting sand mix. Results show that RHA significantly reduced thermal conductivity of the moulding sand from 1.631-1.141 W/m. K (a 30% reduction).However, AlDr increased its thermal conductivity from 1.631-1.787 W/m.K for 1-6 wt. % AlDr, which later dropped progressively from 1.753-1.540 W/m.K for 8-12 wt. %. The moisture content increased abruptly from 4.0-4.2 % for 6-8 wt. % AlDr addition but decreased from 4.0-2.8% for0-6 wt. % RHA addition in the moulding sand mix.
Â
