Article Sidebar
Published:
Dec 28, 2015DOI:
10.4314/njt.v35i1.17Keywords:
Article Details
Copyright belongs to the Faculty of Engineering, University of Nigeria, Nsukka, Nigeria
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from https://www.nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in Statement of Originality.pdf (nijotech.com)
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.
Main Article Content
ANALYSIS OF COCONUT ETHYL ESTER (BIODIESEL) AND FOSSIL DIESEL BLENDING: PROPERTIES AND CORROSION CHARACTERISTICS
Abstract
The effect of biodiesel and its blends synthesized from coconut oil (CNO) via alkali catalyzed transeterification on the key fuel properties and corrosion characteristics of copper were investigated. The transesterification of the CNO via ethanol in the presence of potassium hydroxide was performed and the resulting coconut oil ethyl ester (COEE) was blended with fossil diesel (B0). The fuel properties such as density, kinematic viscosity (KV), pour and cloud points (PP and CP, respectively) and American Petroleum Institute of Gravity (API) of B0, COEE-diesel blend (B50) and COEE (B100) were characterized and compared with that of ASTM D6751 and EN14214 standards. Static immersion tests were conducted by exposing copper coupons toB0, B50 and B100 at different temperatures (50, 65 and 80 oC) for 5 days. Corrosion rates of copper in these fuels were determined by weight loss method. Also, during the period of investigation, these fuels were analyzed by measuring total acid number (TAN). The results showed that the density, KV, PP and CPincreased while the API gravity decreased as the percentage of the biodiesel in the blend increased. The highest corrosion rates for copper at the end of the investigation were 0.054, 0.0954 and 0.139 mpy in B0, B50 and B100, respectively. The minimum TAN (0.17 mg KOH/g) and maximum TAN (0.62 mg KOH/g) were observed in B0 and B100 containing copper, respectively.
