Main Article Content
Alternative streamflow-based approach to estimate catchment response time in medium to large catchments: case study in Primary Drainage Region X, South Africa
Abstract
Event-based estimates of the design flood in ungauged catchments are normally based on a single catchment response time parameter expressed as either the time of concentration (TC), lag time (TL) and/or time to peak (TP). In small, gauged catchments, a simplified convolution process between a single observed hyetograph and hydrograph is generally used to estimate these time parameters. In medium to large heterogeneous, gauged catchments, such a simplification is neither practical nor applicable, given that the variable antecedent soil moisture status resulting from previous rainfall events and spatially non-uniform rainfall hyetographs can result in multi-peaked hydrographs. In ungauged catchments, time parameters are estimated using either empirical or hydraulic methods. In South Africa (SA), unfortunately, the majority of the empirical methods recommended for general use were developed and verified in catchments ≤ 0.45 km² without using any local data. This paper presents the further development and verification of the streamflow-based approach developed by Gericke (2016) to estimate observed TP values and to derive a regional empirical TP equation in Primary Drainage Region X, SA. A semi-automated hydrograph analysis tool was developed to extract and analyse complete hydrographs for time parameter estimation using primary streamflow data from 51 flow-gauging sites. The observed TP values were estimated using three methods: (i) duration of total net rise of a multi-peaked hydrograph, (ii) triangular-shaped direct runoff hydrograph approximations, and (iii) linear catchment response functions. The combined use of these methods incorporated the high variability of event-based time parameters, and Method (iii), in conjunction with an ensemble-event approach sampled from the time parameter distributions, should replace the event-based approaches to enable the improved calibration of empirical time parameter equations. The conceptual approach used to derive the regional empirical TP equation should also be adopted when regional equations need to be derived at a national scale in SA.