Article Sidebar
Published:
Jul 3, 2024Keywords:
Article Details
Tanzania Journal of Engineering and Technology (Tanz. J. Engrg. Technol.) publications are written as a basis for academic discussions. Whereas effort is made by the Editorial Board to screen out inaccurate or misleading statements, data or opinions, Tanz. J. Engrg. Technol. wishes to make it clear that the contents of the articles are the sole responsibility of the authors. Accordingly, the Editorial Board and editors, publisher, College of Engineering and Technology and the University of Dar es Salaam accept no responsibility or liability whatsoever for the opinions, inaccurate or misleading data or statement and views expressed by the authors.
However, the College of Engineering and Technology, the publisher of the Journal, reserve all rights of the articles published in the Journal. Whereas the contents of the articles are available electronically without cost, no part of the publication may be transmitted in any form or reproduced electronically or mechanically, except for short extract in critical scholarly review, research or discourse with an acknowledgement.
Main Article Content
Enhanced post deposition annealing conditions on the fabrication of high quality thermochromic vanadium dioxide films
Abstract
Sputter deposition of thermochromic VO2 thin films for smart window applications has been faced with several challenges including the need for high deposition temperature, extremely precise and narrow range of oxygen/argon flow ratio and target poisoning during sputtering. Deposition of VO2 at room temperature without oxygen followed by post-deposition annealing has been cited as one of the potential mitigations to the challenge. In this study, the effects of post-deposition annealing conditions on the structural, electrical and optical properties of VO2 thin films are reported. The films were prepared on soda lime glass substrates using DC magnetron sputtering of metallic vanadium target in argon atmosphere, at room temperature without oxygen followed by post-deposition annealing. The working pressure and argon flow rate were 5.2 – 5.6 x 10-3 mbar and 76 ml/min, respectively. Thereafter, the films were annealed in a low vacuum environment at different temperatures and times. The XRD results confirmed that all films annealed at different temperatures and times were monoclinic VO2 except for films annealed at a temperature of 300 oC. The results indicate that 400 oC and 20 minutes are the optimum annealing temperature and time, respectively, for fabrication of high quality VO2 films with improved stoichiometry and crystallinity. The films had resistivity change between the semiconducting and metallic phases of one order of magnitude and the transition temperature between 58 oC and 63 oC. The highest peak transmittance and best optical switching of the annealed VO2 films was 53% and 18%, respectively, at a wavelength of 2500 nm for film thickness of 44 nm. The results suggest that room temperature deposition without oxygen followed by post-deposition annealing in a low vacuum environment may be adequate for the fabrication of switching VO2 thin films.
