Article Sidebar
Published:
Feb 28, 2023Keywords:
Article Details
Tanzania Journal of Engineering and Technology (Tanz. J. Engrg. Technol.) publications are written as a basis for academic discussions. Whereas effort is made by the Editorial Board to screen out inaccurate or misleading statements, data or opinions, Tanz. J. Engrg. Technol. wishes to make it clear that the contents of the articles are the sole responsibility of the authors. Accordingly, the Editorial Board and editors, publisher, College of Engineering and Technology and the University of Dar es Salaam accept no responsibility or liability whatsoever for the opinions, inaccurate or misleading data or statement and views expressed by the authors.
However, the College of Engineering and Technology, the publisher of the Journal, reserve all rights of the articles published in the Journal. Whereas the contents of the articles are available electronically without cost, no part of the publication may be transmitted in any form or reproduced electronically or mechanically, except for short extract in critical scholarly review, research or discourse with an acknowledgement.
Main Article Content
Sensible Heat Bean Cooker
Abstract
Alternative cooking energy to replace wood fuels is needed in the African context. Liquified Natural Gas (LNG) is a solution but is still based on burning fossil fuel. Electrical cookers can be an alternative as well. However, for off-grid systems this means electrical batteries are required, as the solar electricity from Photovoltaic (PV) panels is intermittent, and as cooking is also to be made after sunset. Heat storage technologies can provide solutions where available energy is stored in the form of heat for cooking when needed. The challenge is then to develop systems which are robust, safe, and technically simple. A very simple small-scale solution is demonstrated here, for the particular case of cooking beans. An insulated iron cylinder is heated, either in a solar concentrator or by PV-powered heating elements. The stored heat can then be calibrated to the cooking of a given volume of beans. After the cylinder has reached the calibrated temperature during the charging, the pot can be placed and left on the top of the cylinder. When the energy is depleted, the beans should be ready cooked.
