Article Sidebar
Published:
Dec 30, 2022Keywords:
Article Details
Tanzania Journal of Engineering and Technology (Tanz. J. Engrg. Technol.) publications are written as a basis for academic discussions. Whereas effort is made by the Editorial Board to screen out inaccurate or misleading statements, data or opinions, Tanz. J. Engrg. Technol. wishes to make it clear that the contents of the articles are the sole responsibility of the authors. Accordingly, the Editorial Board and editors, publisher, College of Engineering and Technology and the University of Dar es Salaam accept no responsibility or liability whatsoever for the opinions, inaccurate or misleading data or statement and views expressed by the authors.
However, the College of Engineering and Technology, the publisher of the Journal, reserve all rights of the articles published in the Journal. Whereas the contents of the articles are available electronically without cost, no part of the publication may be transmitted in any form or reproduced electronically or mechanically, except for short extract in critical scholarly review, research or discourse with an acknowledgement.
Main Article Content
Analysis of Ore Hand-Crushed Size Distribution for Grinding Process in the Artisanal and Small-Scale Gold Mines Production: A Case Study of Nholi Mine, Bahi District
Abstract
In many parts of the world, artisanal and small-scale gold mines (ASGM) employed numbers of people compared to large-scale mines. The ASGM has been played a crucial role in poverty alleviation and rural development, particularly in developing countries. The mined ore is crushed and ground for beneficiation of gold. The grinding process involved the size reduction of blasted materials to acquire minerals of interest. This paper presents the size distribution of hand-crushed for blasted materials using sieve analysis and digital image processing. The sieve test results for hand-crushed blasted material of three muck-piles were ranged between 17 mm and 36 mm that is equivalent to 20% and 80% passings respectively, with an average of 26 mm. The digital image processing results were about 19.8 mm for 20% passing and 58 mm for 80% passing, with an average of 36.06 mm. The hand-crushed provided a wide range of material distribution than the required size in the grinding unit and increased oversize by 18%. The hand-crushed of blasted materials provides different sizes distribution leading to increase the residence time and power consumption of the grinding units.
