Article Sidebar
Published:
Jun 30, 2008Keywords:
Article Details
Tanzania Journal of Engineering and Technology (Tanz. J. Engrg. Technol.) publications are written as a basis for academic discussions. Whereas effort is made by the Editorial Board to screen out inaccurate or misleading statements, data or opinions, Tanz. J. Engrg. Technol. wishes to make it clear that the contents of the articles are the sole responsibility of the authors. Accordingly, the Editorial Board and editors, publisher, College of Engineering and Technology and the University of Dar es Salaam accept no responsibility or liability whatsoever for the opinions, inaccurate or misleading data or statement and views expressed by the authors.
However, the College of Engineering and Technology, the publisher of the Journal, reserve all rights of the articles published in the Journal. Whereas the contents of the articles are available electronically without cost, no part of the publication may be transmitted in any form or reproduced electronically or mechanically, except for short extract in critical scholarly review, research or discourse with an acknowledgement.
Main Article Content
Improving the Availability of Manufacturability Information through Decentralization of Process Planning
Abstract
Process planning is part of the general product development and production process that usually follows design and precedes manufacturing. Manufacturability and process planning information in general play central role in many product development and production activities, including paradoxically, conceptual and detail design - the activities that take place before process planning. The need of conducting some of the process planning activities formally before or during design is thus rather obvious. One of the main research issues is therefore the identification of the process planning activities that can be performed before the traditional process planning phase and handling of the process planning information so as to adequately provide the designers with the manufacturability information
needed during conceptual and detail design. Another issue is how to support collaboration during process planning and how to maintain continuity of the process planning tasks. This paper suggests the decentralization of the process planning task and proposes the execution of the process planning activities in a piecemeal fashion, starting right after
receiving an order and specifying the requirements for a product. Process planning under the proposed procedure consists of six semi-autonomous sub-phases, some of which comprise activities that must be conducted prior to the process planning phase. This helps to overcome the problem of timely availability of manufacturability information during the execution of upstream and downstream product development and production activities. The paper also
proposes a computer-based method of handling the manufacturability information generated in various stages of the product development and production process. A database design and structure of prototype software that manages the process planning information are presented and discussed. Furthermore, a case study conducted to explore how
the proposed process planning procedure could be put in use is presented and discussed.
