Article Sidebar
Published:
Dec 31, 2008Keywords:
Article Details
Tanzania Journal of Engineering and Technology (Tanz. J. Engrg. Technol.) publications are written as a basis for academic discussions. Whereas effort is made by the Editorial Board to screen out inaccurate or misleading statements, data or opinions, Tanz. J. Engrg. Technol. wishes to make it clear that the contents of the articles are the sole responsibility of the authors. Accordingly, the Editorial Board and editors, publisher, College of Engineering and Technology and the University of Dar es Salaam accept no responsibility or liability whatsoever for the opinions, inaccurate or misleading data or statement and views expressed by the authors.
However, the College of Engineering and Technology, the publisher of the Journal, reserve all rights of the articles published in the Journal. Whereas the contents of the articles are available electronically without cost, no part of the publication may be transmitted in any form or reproduced electronically or mechanically, except for short extract in critical scholarly review, research or discourse with an acknowledgement.
Main Article Content
Identification of Unbalanced Forces and Foundation Parameters of Rotating Machines from Vibration Measurements
Abstract
A technique is described to use measured vibration data of a rotating machine and its foundation to identify unbalanced forces, stiffness and damping parameters of the mountings, and the parameters of the foundation. It is based on an idealisation treating the rotor, the machine structure and the foundation as rigid masses supported by springs and dampers. Operational vibration data of the machine and its foundation before and
after the rotating unbalanced forces are perturbed by adding unbalanced mass to the rotor are used in the identification procedure. Once the parameters are identified, dynamic forces transmitted to the foundation can be estimated. The technique is demonstrated using simulated example for a machine with a two bearings rotor.
