Article Sidebar
Published:
Dec 31, 2013Keywords:
Article Details
Tanzania Journal of Engineering and Technology (Tanz. J. Engrg. Technol.) publications are written as a basis for academic discussions. Whereas effort is made by the Editorial Board to screen out inaccurate or misleading statements, data or opinions, Tanz. J. Engrg. Technol. wishes to make it clear that the contents of the articles are the sole responsibility of the authors. Accordingly, the Editorial Board and editors, publisher, College of Engineering and Technology and the University of Dar es Salaam accept no responsibility or liability whatsoever for the opinions, inaccurate or misleading data or statement and views expressed by the authors.
However, the College of Engineering and Technology, the publisher of the Journal, reserve all rights of the articles published in the Journal. Whereas the contents of the articles are available electronically without cost, no part of the publication may be transmitted in any form or reproduced electronically or mechanically, except for short extract in critical scholarly review, research or discourse with an acknowledgement.
Main Article Content
Analysis of Power Efficiency of a Direct-Driven Locally Fabricated Permanent Magnet Ac Generator for Small-Scale Wind Power Applications in Tanzania
Abstract
The use of direct-driven permanent magnet alternating current (AC) generators offers the opportunity to reduced costs and increased system efficiency. This type of generator could be the best alternative for rural population whom are not connected to the national grid. To improve the design and efficiency of locally fabricated generators, it is imperative to
characterize both their mechanical and electrical parameters. This paper presents the analysis of power efficiency of the synchronous permanent AC generator locally fabricated in Tanzania. In this case, load resistance and rotational speed are characterized using designed experiment. The output current and voltage of the generator were recorded simultaneously in each step change of load resistance and rotational speed. The output power and efficiency were then determined analytically. The results show that there is a linear relationship between voltage and rotational speed of the generator with and without load resistance. The results further indicated that out power is not linearly related to rotational speed. The generator•s power efficiency was found to be about 55% against both the output voltage and rotational speed.
