Article Sidebar
Published:
Jun 30, 2014Keywords:
Article Details
Tanzania Journal of Engineering and Technology (Tanz. J. Engrg. Technol.) publications are written as a basis for academic discussions. Whereas effort is made by the Editorial Board to screen out inaccurate or misleading statements, data or opinions, Tanz. J. Engrg. Technol. wishes to make it clear that the contents of the articles are the sole responsibility of the authors. Accordingly, the Editorial Board and editors, publisher, College of Engineering and Technology and the University of Dar es Salaam accept no responsibility or liability whatsoever for the opinions, inaccurate or misleading data or statement and views expressed by the authors.
However, the College of Engineering and Technology, the publisher of the Journal, reserve all rights of the articles published in the Journal. Whereas the contents of the articles are available electronically without cost, no part of the publication may be transmitted in any form or reproduced electronically or mechanically, except for short extract in critical scholarly review, research or discourse with an acknowledgement.
Main Article Content
Analysis of Different Techniques for Improving Performance of Flat Plate Solar Collectors for Fruits Drying
Abstract
Fruits drying had become a broader technology in fruits and vegetables value addition.
The technology is reported to be a promising way of drying without incurring higher cost
but its adaptation has not been feasible in rural areas. Solar dryers have been developed
but its poor performance limits its applicability. In this study, several techniques for
modifications of traditional solar collector were addressed. It was observed that, varying
collector designs in different techniques, a range of collector performances can be
archived. The research shows that, collector efficiency can be improved by 9.6% when
employing double duct counter flow compared to conventional collectors. Likewise,
performance difference between conventional collectors and studied models were found to
be 8%, 7.2%, 6.1% and 5.2% for model parked with charcoal, 5 mm wire mesh, 4 mm
glass thickness and 8 baffles respectively. This study shows that, double duct counter flow
system is the best option for improving the performance of the collectors, followed by
charcoal and wire mesh. On the hand, using 4 mm glass thickness gave improved
performance, however, it is recommended for collector size not exceeding 2 m in length.
