Article Sidebar
Published:
Dec 31, 2017Keywords:
Article Details
Tanzania Journal of Engineering and Technology (Tanz. J. Engrg. Technol.) publications are written as a basis for academic discussions. Whereas effort is made by the Editorial Board to screen out inaccurate or misleading statements, data or opinions, Tanz. J. Engrg. Technol. wishes to make it clear that the contents of the articles are the sole responsibility of the authors. Accordingly, the Editorial Board and editors, publisher, College of Engineering and Technology and the University of Dar es Salaam accept no responsibility or liability whatsoever for the opinions, inaccurate or misleading data or statement and views expressed by the authors.
However, the College of Engineering and Technology, the publisher of the Journal, reserve all rights of the articles published in the Journal. Whereas the contents of the articles are available electronically without cost, no part of the publication may be transmitted in any form or reproduced electronically or mechanically, except for short extract in critical scholarly review, research or discourse with an acknowledgement.
Main Article Content
Handling of Syringe Sharps in A Non-Incineration Health Care Waste Disposal
Abstract
An attempt has been made by the R&D team of the University of Dar es Salaam to
design and manufacture two needle cutter prototypes, a manually operated and an
automatic needle cutter to be used in rural and urban areas, respectively. This is part of
the UNDP and WHO efforts aimed at promoting the non-burn medical waste disposal
technologies in developing countries such as Argentina, India, Latvia, Lebanon,
Philippines, Senegal, Tanzania and Vietnam. The project also involves designing and
manufacturing of the autoclaves for sterilizing of needle cutters and other infectious
medical waste. The use of needle cutters in hospitals is aimed at cutting the needles off
from syringes hence eliminating the possibility of being re-used as may be the case if
they are just buried in landfills. The needles and plastic barrels of the syringes are then
sterilized at 121 o C in an autoclave before disposing them in land-fills or recycling them.
It should be noted that unlike manual needle cutters, automatic needle cutters do not add
a step in administering injection and hence they are likely to be accepted by nurses and
health care authorities. Two types of automatic cutter prototypes were developed by
UDSM R&D Team; one using pneumatic mechanisms and the other one using a 12V-
DC motor to cut the syringe needles and to push the plastic barrel into the waste
container. Of the two, the 12V-DC motor operated mechanism was found to be
affordable and suitable for use in rural areas also since it can easily use solar power.
The above prototypes have already been manufactured and tested and found to be
working properly. Views of various stakeholders were used to improve and perfect the
designs. The costs of these prototypes are estimated to be USD 50 and 150 for manually
operated needle cutter and 12V-DC operated needle cutter, respectively. These
technologies, except the automatic needle cutters, have already been disseminated to
local producers so as to be able to manufacture the same in mass production and at
much more affordable costs. Training on the use of non-burn technologies including
management of medical waste is essential for successful implementation of these
technologies. There is a need also to sensitize the Government, Municipal Authorities
and Healthcare Authorities including hospitals on non-burn disposal of medical waste
for the project to be successful.
