Article Sidebar
Published:
Dec 31, 2017Keywords:
Article Details
Tanzania Journal of Engineering and Technology (Tanz. J. Engrg. Technol.) publications are written as a basis for academic discussions. Whereas effort is made by the Editorial Board to screen out inaccurate or misleading statements, data or opinions, Tanz. J. Engrg. Technol. wishes to make it clear that the contents of the articles are the sole responsibility of the authors. Accordingly, the Editorial Board and editors, publisher, College of Engineering and Technology and the University of Dar es Salaam accept no responsibility or liability whatsoever for the opinions, inaccurate or misleading data or statement and views expressed by the authors.
However, the College of Engineering and Technology, the publisher of the Journal, reserve all rights of the articles published in the Journal. Whereas the contents of the articles are available electronically without cost, no part of the publication may be transmitted in any form or reproduced electronically or mechanically, except for short extract in critical scholarly review, research or discourse with an acknowledgement.
Main Article Content
Moisture Induced Deformations in Glulam Members - Experiments and 3-D Finite Element Model
Abstract
Experiments were performed on scaled glue laminated bending specimens to observe
time dependent development of deformations during drying and wetting. Measurements
determined changes in the average moisture content and external shape and dimensions
between when specimens were placed into constant or variable climates. Alterations in
the external shape and dimensions reflected changes in the average value and
distribution of moisture and mechanosorptive creep in the glulam. The results are being
used to develop a sequentially-coupled three-dimensional hygrothermal Finite Element
(FE) model for predicting temporally varying internal strains and external deformations
of drying or wetting solid wood structural components. The model implies temporally
varying, and eventual steady, state internal stress distributions in members based on
elastic and creep compliances that represent wood within glulam as a continuous
orthotropic homogenised material. Thus, predictions are consistent with smeared
engineering stress analysis methods rather than being a physically correct analogue of
how solid wood behaves. This paper discusses limitations of and intended improvements
to the FE modelling. Complementary investigations are underway to address other
aspects of the hygrothermal behaviour of structural members of wood and other
materials (e.g. reinforced concrete) embedded within superstructure frameworks of
multi-storey hybrid buildings.
