Article Sidebar
Published:
Oct 15, 2023Keywords:
Article Details
In accordance with the Copyright Act of 1976, which became effective January 1, 1978, the following statement signed by each author must accompany the manuscript submitted: "I, the undersigned author, transfer all copyright ownership of the manuscript referenced above to the Nigerian Journal of Technological Development, in the event the work is published. I warrant that the article is original, does not infringe upon any copyright or other proprietary right of any third party, is not under consideration by another journal, and has not been published previously. I have reviewed and approve the submitted version of the manuscript and agree to its publication in the Nigerian Journal of Technological Development." A copyright transfer form may be downloaded from the NJTD Website (http://njtd.com.ng/index.php/njtd). Author(s) will be consulted, whenever possible, regarding republication of material. All authors must have access to the data presented and the authors and sponsor (if applicable) must agree to share original data with the editor if requested.
Main Article Content
Mechanical characteristics and regression models of rice husk silica reinforced natural rubber composites
Abstract
Carbon black and silica fillers have been widely used as reinforcing fillers in tyres and engine mounts. However, both fillers are non-renewable and with REACH legislation in Europe, the USA and elsewhere, where some of these fillers are termed hazardous due to the presence of polyaromatic hydrocarbons (PAHs), there is a need to search for sustainable alternative fillers to wholly or partially replace carbon black as a filler. This research studied rice husks-derived silica (RHS) as a filler in natural rubber (NR). The characteristics of RHS at 50 phr to 90 phr filler loading levels were examined to determine its suitability as a substitute for unsustainable carbon black (N772) fillers used in the rubber industry. Bound rubber content, crosslink density, tensile strength, young modulus, tear strength, shore A hardness, compressive set, and elongation at break were measured. Regression models were generated and the correlation of determination (R2) values was obtained. The RHS composites resulted in maximum tensile strength of 13.20 MPa at 90 phr, tear strength of 119 MPa at 90 phr, shore A hardness of 69 at 90 phr, compressive set of 6.72% at 80 and 90 phr, elongation at break of 453.60% at 80 phr, bound rubber content of 92.14% at 50 phr and crosslink density of 3.87×10-2 mol/cm3 at 70 phr. The results obtained were within the range of those obtained for the carbon black filled composites across various loading levels. The R2 value of mechanical characteristics for the RHS and N772 samples respectively were 50.06% and 62.18% (bound rubber content), 97.62% and 99.85% (tensile strength), 98.44% and 63.97% (tear strength), 89.16 and 97.40% (Shore A hardness), 32.90% and 91.80% (compressive set), a d 50.91% and 46.91% (elongation at break). Rice husk-derived Silica filled natural rubber composites showed favourable mechanical properties and can substitute traditional fillers in tyres, rubber engine mounts, bushings, seals and doormats.
