Article Sidebar
Published:
Sep 23, 2022DOI:
10.4314/njtd.v19i3.5Keywords:
Article Details
In accordance with the Copyright Act of 1976, which became effective January 1, 1978, the following statement signed by each author must accompany the manuscript submitted: "I, the undersigned author, transfer all copyright ownership of the manuscript referenced above to the Nigerian Journal of Technological Development, in the event the work is published. I warrant that the article is original, does not infringe upon any copyright or other proprietary right of any third party, is not under consideration by another journal, and has not been published previously. I have reviewed and approve the submitted version of the manuscript and agree to its publication in the Nigerian Journal of Technological Development." A copyright transfer form may be downloaded from the NJTD Website (http://njtd.com.ng/index.php/njtd). Author(s) will be consulted, whenever possible, regarding republication of material. All authors must have access to the data presented and the authors and sponsor (if applicable) must agree to share original data with the editor if requested.
Main Article Content
Study of the Effect of Quenchants on the Machinability of Heat Treated Mild-Steel
Abstract
Heat treated steels that are quenched rapidly show an increase in hardness and toughness but also show an increase in brittleness which could lead to a higher surface roughness and low material removal rate while machining. Hence, the choice of quenchants has a significant effect on the hardness of low carbon steels. In this research work, the effect of some selected quenchants on the mechanical properties of heat treated and machined mild steel was investigated. Four samples of the carbon steel rods were furnace heated at 8500C and quenched with water, molten salt, potash alum and used engine oil. Central Composite Designs of Design Expert version 12 was used to plan the experiment. Machining factors used were, speed (100-450 rpm), feed rate (0.01-0.03 mm/rev), depth of cut (1-2mm). Surface roughness and material removal rate as well as the results of quenchant characterization were the responses studied. The favored quenchant was oil with the lowest surface roughness, hardness and material removal rate of 0.33μm and 187.78BHN and 0.020133mm3/min respectively. This is because the use of oil resulted in the highest reduction in surface roughness and enhanced material removal rate.
