Article Sidebar
Published:
Jun 6, 2022DOI:
10.4314/njtd.v19i1.8Keywords:
Article Details
In accordance with the Copyright Act of 1976, which became effective January 1, 1978, the following statement signed by each author must accompany the manuscript submitted: "I, the undersigned author, transfer all copyright ownership of the manuscript referenced above to the Nigerian Journal of Technological Development, in the event the work is published. I warrant that the article is original, does not infringe upon any copyright or other proprietary right of any third party, is not under consideration by another journal, and has not been published previously. I have reviewed and approve the submitted version of the manuscript and agree to its publication in the Nigerian Journal of Technological Development." A copyright transfer form may be downloaded from the NJTD Website (http://njtd.com.ng/index.php/njtd). Author(s) will be consulted, whenever possible, regarding republication of material. All authors must have access to the data presented and the authors and sponsor (if applicable) must agree to share original data with the editor if requested.
Main Article Content
Impact of structural dimensions and poles on the torque performance of dual-stator permanent magnet machines
Abstract
The impact of structural dimensions and rotor pole numbers on the load and no-load torques of dual stator permanent magnet machine is investigated and presented in this work. Finite element analysis (FEA) is adopted in the prediction, since it exhibits higher computation accuracy compared to other methods such as analytical modelling and techniques, etc. Version 15.0 of MAXWELL/ANSYS-2D software is implemented in the entire computations. The considered structural dimensions include: rotor centrifugal size (Rth), aspect ratio (Sr), permanent magnet width (Mth), outer stator tooth width (Tth), rotor outer pole arc/pitch ratio (ϒ1) and rotor inner pole arc/pitch ratio (ϒ2). Also, model topologies having stator pole (S) and rotor pole (P) numbers i.e. 6S/10P, 6S/11P, 6S/13P and 6S/14P, are compared. The results show that the shaft torque and no-load torque would reasonably depend on the adopted machine’s structural dimensions; in addition to the impact of rotor pole number. More so, it is observed that the optimal output torque of a given machine may not necessarily occur at the same operating structural point with that of the required least no-load torque. Implementation of the optimum structural dimensions would result to largest average output electromagnetic torque from the machine. Moreover, practically all the most optimum results are obtained from the 6S/11P machine type. The useable average shaft torque from the simulated models is approximately: 2.33 Nm, 4.16 Nm, 3.75 Nm and 2.31 Nm, for the 6S/10P, 6S/11P, 6S/13P and 6S/14P categories, respectively. Similarly, least values of the no-load torque in the compared machine types are 1.2 Nm, 0.08 Nm, 0.04 Nm and 0.68 Nm i.e. for the 6S/10P, 6S/11P, 6S/13P and 6S/14P machine topologies.
