Article Sidebar
Published:
Oct 29, 2020DOI:
10.4314/njtd.v17i3.8Keywords:
Article Details
In accordance with the Copyright Act of 1976, which became effective January 1, 1978, the following statement signed by each author must accompany the manuscript submitted: "I, the undersigned author, transfer all copyright ownership of the manuscript referenced above to the Nigerian Journal of Technological Development, in the event the work is published. I warrant that the article is original, does not infringe upon any copyright or other proprietary right of any third party, is not under consideration by another journal, and has not been published previously. I have reviewed and approve the submitted version of the manuscript and agree to its publication in the Nigerian Journal of Technological Development." A copyright transfer form may be downloaded from the NJTD Website (http://njtd.com.ng/index.php/njtd). Author(s) will be consulted, whenever possible, regarding republication of material. All authors must have access to the data presented and the authors and sponsor (if applicable) must agree to share original data with the editor if requested.
Main Article Content
Evaluating the Quality Assurance and Control of Hot-Mix Asphalt from Selected Plants in South West, Nigeria
Abstract
Roads are essential necessity of every nation and it is possible that even with proper designs, the roads might not be constructed to the design standard due to poor quality assurance and control resulting in poor pavement quality. This study presents experimental results carried out on various hot - mix asphalt (HMA) samples obtained across different Asphalt plants in South West Nigeria. This was done to determine the extent to which the HMA used in the construction and rehabilitation of Nigerian roads affect their service life. Six samples of the asphalt binder (bitumen) were obtained from each plant over a period of six months and tested. The tested properties were assessed based on the level of conformance with the specifications and requirements from the FMWH General Specification (Roads and Bridges). The results revealed that HMA from plant B had a specific gravity of 1.01, penetration of 65.00 mm, softening point of 53 oC, flash point of 237.00 oC, peak Marshall Stability of 18.25 kN, flow of 3.87 mm and voids in total mixture peak value of 5.08 %. HMA from plant E had a specific gravity of 1.03, penetration of 65.00 mm, softening point of 51 oC, flash point of 239.00 oC, peak marshall stability of 18.26 kN, flow of 3.67 mm and voids in total mixture peak value of 4.99 % and these were adjudged the best in conformance with the FMWH specifications. Adequate monitoring of HMA quality for either binder or wearing courses by carrying out quality control and assurance tests is thereby recommended as it affects pavement durability and performance.
Keywords: Hot-mix asphalt, quality assurance, quality control, marshall stability, flow test
