Article Sidebar
DOI:
10.4314/mejs.v7i2.3Article Details
The Momona Ethiopian Journal of Science accepts the manuscripts for consideration with the understanding that the manuscript has not been published and is not under consideration for publication elsewhere. Only original articles will be considered for publication if they have been published previously as abstracts, but not if they have been published previously as extended abstract (>1000 words). This applies to both electronic and print versions of the journal. The authors should assign copyright ownership to the Editorial Office of MEJS in the event that the manuscript is accepted for publication in the Momona Ethiopian Journal of Science. All accepted manuscripts must be accompanied by a copyright statement signed by all authors. A copy of the copyright form will be supplied along with the final reviewed version of the manuscript that is sent for final proof- reading. Authors may make multiple copies of the form if necessary and send to the Editorial Office with author’s signature(s) even individually.
All articles published by Momona Ethiopian Journal of Science (MEJS) are Open Access under the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0). Under this license, authors retain ownership of the copyright for their content, and anyone can copy, distribute, or reuse articles as long as the author and original source are properly cited. In all these cases for re-use, the authors will be given proper credit to the original publication in MEJS.
Main Article Content
Performance of Wind Pump Prototype
Abstract
A wind pump prototype with 3.6 m rotor diameter, 19 m hub height above ground and 0.22 mm reciprocating pump stroke has been developed at the Department of Mechanical Engineering, Mekelle University. The prototype was designed and manufactured locally. Theoretical model based on combined efficiency of the rotor and the reciprocating pump was used to estimate the performance of the wind pump. One year wind speed data collected at 10 m height was extrapolated to the wind pump hub height using wind shear coefficient. The model assumed balanced rotor power and reciprocating pump, hence did not consider the effect of pump size. The theoretical model estimated the average daily discharge to be around 50 m3 and 30 m3 at 8 m and 12 m head, respectively. The prototype was tested with the same pump stroke but two different size pumps at two different heads. The pumps were with internal diameter of 55 and 70 mm and the test heads were at 8 and 12 m. Measurement of the flow rate, rotational speed and wind speed were made every 10 minutes during the test period. The data collected were analyzed to find the performance of the wind pump at the two test heads and two pump sizes. The flow rate data was plotted against binned wind speed data to determine the linear fit function. The linear fit function was then used to estimate the flow rate at any wind speed. With the 55 mm pump the measured average daily discharge was 20 and 19 m3 at 8 m and 12 m head, respectively. With the 70 mm pump the measured average daily discharge was 41 m3 and 30 m3 at 8 m and 12 m head, respectively.
Keywords: Wind pump, Windmill, Performance testing, Pump efficiency, Pump discharge, Ethiopia.
