Article Sidebar
Published:
Feb 14, 2024Keywords:
Article Details
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
Open Access authors retain the copyrights of their papers, and all open access articles are distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution and reproduction in any medium, provided that the original work is properly cited.
The use of general descriptive names, trade names, trademarks, and so forth in this publication, even if not specifically identified, does not imply that these names are not protected by the relevant laws and regulations.
While the advice and information in this journal Area believed to be true and accurate on the date of its going to press, neither the authors, the editors, nor the publisher can accept any legal responsibility for any errors or omissions that may be made. The publisher makes no warranty, express or implied, with respect to the material contained herein.
Main Article Content
Insight into rotational effects on a horizontal axis wind turbine NREL phase II using CFD simulation and inverse BEM
Abstract
The present work aims to study the aerodynamic characteristics of the NREL phase II rotor (generated only with S809 profile along the span for an untwisted case) that is a horizontal axis downwind wind turbine rotor and which is assumed to stand isolated in the space. The three-dimensional steady-incompressible flow Reynolds Averaged Navier-Stokes equations are solved by using the commercial CFD package ANSYS FLUENT and, the turbulence closure model k-ω with shear stress transport correction was adopted for all computations. The computations were done for wind speed of 7.2, 10.56, 12.85, 16.3, and 9.18 m.s-1. Results of pressure and torque for considered wind turbine rotor have been directly compared to the available experimental data. The comparisons show that CFD results along with the turbulence model can predict the spanwise loading of the wind turbine rotor with reasonable agreement. Secondly, A comparison of lift and drag coefficients was made between the results obtained using the inverse algorithm BEM based on the calculated pressure distributions and the experimental test data. The result show that the general trend is similar for all sections of the scale, however, large deviation exists between the 2-D and 3-D case.
