About the Journal

Publisher

Publisher: Faculty of Technology, University of El Oued, Algeria

Publisher contact person: Dr. Abdelmalek ATIA

Email: abdelmalek-atia@univ-eloued.dz

Mailing address: University of El Oued, Algeria

Sources of Support

There is no support. Only volunteered by the professors of the faculty of Technology, University of El Oued, Algeria

Peer Review

All submitted papers will be reviewed by double blind peer review process which may take minimum 02 to 04 weeks from the date of submission. We are advising to all the author(s), do not submit same paper to the multiple journals. Author(s) should wait for review status of paper.

We are committed to prompt evaluation and publication of fully accepted papers in Algerian Journal of Engineering and Technology. To maintain a high-quality publication, all submissions undergo a rigorous process. Characteristics of the peer review process are as follows:

Simultaneous submissions of the same manuscript to different journals will not be tolerated.
Manuscripts with contents outside the scope will not be considered for review.
Depending on individual journal policy, submissions usually will be refereed by 3 experts as suggested by the editorial board.
In addition, Editors will have the option of seeking additional reviews when needed. Authors will be informed when Editors decide further review is required.
All publication decisions are made by the journal Editor-in-Chief on the basis of the referees' reports. Authors of papers that are not accepted are notified promptly.
All submitted manuscripts are treated as confidential documents. We expect our Board of Reviewing Editors and reviewers to treat manuscripts as confidential material as well.
Editors and reviewers involved in the review process should disclose conflicts of interest resulting from direct competitive, collaborative, or other relationships with any of the authors, and remove oneself from cases in which such conflicts preclude an objective evaluation. Privileged information or ideas that are obtained through peer review must not be used for competitive gain.
Our peer review process is confidential and identities of reviewers cannot be revealed.
All manuscripts submitted for publication in journal cross-checked for plagiarism software. Manuscripts found to be plagiarized during initial stages of review are out-rightly rejected and not considered for publication in the journal.
In case if a manuscript is found to be plagiarized after publication, the Editor-in-Chief will conduct preliminary investigation, may be with the help of a suitable committee constituted for the purpose. If the manuscript is found to be plagiarized beyond the acceptable limits, the journal will contact the author’s Institute / College / University and Funding Agency, if any.

Open Access Policy

Algerian Journal of Engineering and Technology (AJET) is an open access journal. Articles in the journal are free to access, download, share, and re-use.

Algerian Journal of Engineering and Technology also operates under the Creative Commons License CC-BY-NC. This allows for the reproduction of articles, free of charge, for non-commercial use only and with the appropriate citation information. All authors publishing with the AJET accept these as the terms of publication.

Articles in this journal are published under the terms and conditions of the Creative Commons Attribution-NonCommercial 4.0 International License.